Product Development Technician

• Preforming load & rate test of springs (Clamp or Unclamped) and storage of load & rate data chart on network.
• Keep the testing lab, as well as fatigue testing equipment clean and all testing equipment organized and in good working condition.
• Set-up and monitoring of fatigue testing samples, ability to follow instruction as outlined on (PA-12 FOI fatigue or rate test request\plan) and log progress thru the fatigue testing life cycles. Turn in data collected upon testing completion, for storage on network.
• Observe new prototype thru the shop floor, and log issues, retrieve and store Quality inspection sheets or difficulties in processing.
• Build small run new prototype and record all dimensional on Spec, turn in dimensional finding to product development manager for storage on network.
• Monitor new (Dies) heat treat forms on 1st time being used, check to ensure that no burr, high spot are causing kinks, mark across leaves, pad marks, etc...
• Locate possible heat treat forms for new product, if no new forms are being built.
• Test these forms for fit & function, and F/H achievement before processing thru heat treat.
• Verify Parts meet specification using approved check gauges.
• Responsible to wear all provided safety equipment for safe job performance.
  
  

• Must possesses strong ability to read & comprehend Spec and drawings.
• Ability to work with high-tech equipment, faro-arm, load & rate tester, fatigue testing equipment, as well as 2 axis fatigue testing equipment.
• Ability to learn advance software, for testing equipment.
• Leadership ability to schedule & follow prototype thru the production shop floor.
• Ability to maintain proper documentation & info of prototype processing thru shop floor.
• Must work well with peer, with ability to verbally communicate task to production workers \ or supervisors.
• Maintain professional posture \ calmness under pressure.
  
  

#LI-NO1

#DaytonParts